Malibu Boats Sunsetter Spécifications Page 30

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 40
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 29
28
2. Wax the boat hull and deck after every three or four outings to decrease water friction and to lessen
the potential for staining or spotting to the gelcoat surface. In cases where the original gelcoat
shine cannot be restored by waxing, hand buff the surface using any commercial compound. Be
sure to apply several coats of wax over the area that has been polished.
66XXUUIIDFHDFH66WWDDLLQQVV
Stains can appear as a result of dust, road tar, plant sap, rust from metal fittings, and other materials
coming in contact with your boat's exterior. Listed below is a step-by-step procedure to remove stains from
your boat:
1. Wash area with dishwashing soap.
2. Apply a mild cleanser on a small area (3' by 3').
3. Rinse with fresh water.
4. Buff with a fine rubbing compound.
5. Wax.
If the stain is not removed by the dishwashing soap or mild cleanser, then the next procedure is to use
either denatured or rubbing alcohol. Common rubbing alcohol is excellent for removing stains.
66FFUUDDWWFKHFKHVV
Scratches to the gelcoat sometimes occur during normal use. Your dealer can usually restore the gelcoat
to like-new condition.
88QGHQGHUUZZDDWWHHUU&&RRUUUURRVVLLRQRQ
Corrosion occurs in saltwater conditions from the interaction of the saltwater and the direct current of the
battery. To prevent corrosion, it is important to keep the bilge area as dry and clean as possible.
&&DDUUH)RH)RUU%%RDRDWWVV77KDKDWW$$UUHH00RRRRUUHGHG
Due to gelcoat discoloration, osmosis (blistering), and algae growth, it is not recommended that you leave
your boat moored for long periods of time. If your boat will be moored in fresh water or saltwater for
extended periods of time, you should do the following:
1. Haul-out and clean your boat regularly (every 14-21 days). Use soap, water, and plenty of elbow
grease.
2. Apply wax after cleaning.
You should also check with your local Malibu dealer about anti-fouling paint and other products that can be
applied to the hull bottom below the water line.
,QWHULRU
::$5$511,,1*1*
Never use harsh soaps, porcelain cleaning powders, detergents containing ammonia or chlorine,
acetone, or ketone solvents.
::$5$511,,1*1*
Do not use acetone, ketone, or other solvents to remove stains. These chemicals are flammable
and may also cause damage to the gelcoat.
Vue de la page 29
1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 39 40

Commentaires sur ces manuels

Pas de commentaire